Projections
First angle and third angle projection methods are acceptable.
The symbol identifying the type of projection used should be placed in a space provided in the drawing block
Views Using Reference Arrows.
Principal View
The principal view on which all of the other views are based should be selected
as being the most informative. This may be the view which is most recognisable during manufacture
or use. i.e. the front view of a house or the side view of a car.
Lines Used on Drawings..
| Line | Description.......... | Application |
| Continuous Thick | Outline Edge |
| Continuous Thin | Intersection.. Dimension.. Projection Leader.. Hatching |
| Continuous Freehand | Limits of Partial or interrupted view |
| Continuous Thin With Zigzags | Shortened Sections |
| Dashed Thick | Hidden Outlines Hidden Edges |
| Dashed Thin | Hidden Outlines Hidden Edges |
| Chain Thin | Centre lines Lines of Symmetry |
| Chain Thick | Special Surfaces |
| Chain Thin Thick ends | Cutting Planes |
| Chain Thin double-dashed | Centroidal Lines Initial Outlines Prior to Forming /Machining |
FIGURE SHOWING LINETYPES
Line Thicknesses
Two thicknesses of line should be used on a drawing. The "thick" line should be at least twice as thick as the "thin" line. The thickness of the line should be based on the sizes... 0,18mm 0,25mm 0,35mm 0,5mm 0,7mm 1,0mm 1.4mm and 2mm
Line spacing
The minimum space between parallel lines should always be greater than twice the thickness of the heaviest line.Leader Lines
- With a dot if they end within the outline of the item being identified.
- With an arrow if they end on the outline
- Without a dot or an arrow when pointing at a dimensions line
Leader Lines terminate
Lettering
Lettering should all be in capitals and underlining should be avoided. The lettering size should be at least 3mm on the finished drawing/ plot.
With the normal paper in landscape orientation and the title block on the bottom right and side, notes to be parallel with the bottom edge.
General notes shall be normally grouped together. Notes related to specific views may be located adjacent to the view.
Hatching
Hatching is used to show areas of sections.
In case of large areas the hatching may be limited to a zone following the contour of the hatched area